JOLLY-A PROGRAMMABLE CHANGE-OVER SWITCH FOR INJECTION CARS
GENERAL CHARACTERISTICS

Programmable change-over switch without necessity of settings on mechanicalregisters (trimmer). Possibility of coupling with sensor levels type VIP1 or AEB (through menù of programming) or sensor 0-90 ohm (by hardware). Other type of sensors on request (order with at least a quantity). Collecting turns engine from the negative coil, from the revolution counter or through inductive coupling with the A.T cable. Easy setting into menù driven by the LED of the change-over switch itself. Furnished with a setting standard pre-fixed from the builder, alterable in easy way. Possibility of personalize with mark on the frontal panel.

JOLLY-H PROGRAMMABLE CHANGE-OVER SWITCH FOR INJECTION CARS
WITH LEVEL SENSOR HALL EFFECT.
GENERAL CHARACTERISTICS
 
Same characteristics of the other but with this difference:
Planning from the change-over switch of the minimum level (reserve) with possibility of manual correction, and the maximum level (full). In this way the errors owed to the type of tank are eliminated . This setting must be performed in phase of installation for optimize the reading of the level.

CONTROL SYSTEM LAMBDA SERIES VIP100-VIP200

	We indicate only any of the salient characteristics of the devices, that they surely are to the avant-garde respects other products currently in commerce; greater information could be require through e-mail or directly by our firm.
Vip-100
Control operation to regular temperature of the lambda probe.
Function checks changing of gears.
Function of over-boost.
Visualization of the state of the mixture through 3 led on the circuit,     or on external tester.
Signaling anomaly of lambda probe.
Simple wiring to install.
Vip-200
Beyond the functions of the Vip-100
Simple and driven setting from the visualization of the led on the circuit.
Self learning of the type of tps sensor.
Operation to the minimum of the stepper motor     (it could be setted that to the minimum don't works, or that works).
Safety cut-off when you commuted to gasoline.
Learning of the optimal carburization for the motor in phase of setting.
RESERVE SENSOR
Reserve sensor for multivalve R67-01 like Tomasetto, Emer, Emmegas. It could be regulated in way to be able adjust the reading of reserve, acting directly on the container of the same sensor. It allow the analogic reading of the LPG level in the tank.
LEVEL SENSORS

The level sensors of LPG GSA2001 they have combined, to each switch predisposed for indicator. They are of simple installation, fixed directly on the multivalve. They allow the mechanical reading in each situation directly on the multivalve, through the indicator of quarters of level. The sensor, to inserted panel, is always illuminated for allow the reading in any condition. They have built in diversified models: for cylindrical tank, or toroidal tank, to allow a more precise indication than the level of fuel.
 

CODE

DESCRIPTION

GSA 2001 C

Sensor for M.V.67R01 for cylindrical tank.

GSA 2001 T

Sensor for M.V.67R01 for toroidal tank.

 
N.B. IT IS POSSIBLE ASSEMBLE THE SENSOR GSA2001 ON THE PRICIPAL BRANDS OF MULTIVALVES.